Slingshots Forum banner

1/4" steel and single 1632?

2K views 11 replies 10 participants last post by  Northerner 
#1 ·
I'm asking because I'm lazy. I was thinking of using some single 1632 rubber on a small frame I made. Would that be adequate to shoot 1/4" steel? I've been using double looped and shooting 3/8" steel, but wanted to try a smaller ammo on a dedicated frame. What do you think? Or do you prefer a different type of ammo for single 1632?
 
Discussion starter · #5 ·
Already set it up! Should have it posted in the homemade section in a little bit. Shot about 8 shots real quick, liked the velocity. Great for plinking, but not overkill.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top