Slingshots Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
3,657 Posts
All good advise here! There's truth in what Matt said about your glue melting. When I do mine I get them roughly where I want them, then pin them so the pins hold it all together, then I do all my final shaping and polishing. When I'm where I want it I carefully push the pins out and epoxy it. Wipe the access off with a wet rag and I'm done, sometimes there's some final touch up sanding where the pins are.

I started doing it this way a lot because when I anodize a part of it it all has to come apart to anodize, then all go back together seamlessly. And I can't be sanding on the anodized portions once I'm done.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top