Slingshots Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,027 Posts
Well, it is a boardcut. Making another one is probably easier than repairing the broken frame.

If for some reason a repair job is desirable anyhow, then I would break it all the way into the two parts, drill an 8,5mm hole into the two halves (as deep as possible), and then I would cut off a matching 8 mm steel rod piece, then smear away with epoxy and press the halves together.

But again, it is probably easier to cut out a clone.

Jörg
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top