Where I need help is the very first cut. So at the top of the flatband material I measure an inch in, and mark it. It's the bottom which I want at 1/2" - how do I measure? I've seen videos where the top is measured at say an inch, then measured at the bottom say 3/4" but there isn't a first cut. Then on other videos I see guys make a first cut to get the angle then discard the excess. I hope I explained this properly! Any assistance is greatly appreciated.
What Palmettoflyer said.
The bands cut this way are not perfect symmetrical tapers. Each end of each band will have one right angle - but it is of no consequence.
The bands cut this way are not perfect symmetrical tapers. Each end of each band will have one right angle - but it is of no consequence.
