Slingshots Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
OK, I'm guessing this type of fork has been done before....Maybe not? The fork is aluminum corner about 1" X 1", 1/8" in thickness, cut and shaped as you see - Handle is stabilized curly maple - I've marked where it could be made for tubes or flats or both - You can't them them but on the side of the fork I also put a mark for flat bands - I might even finish this one someday.....Maybe not!?!?
 

Attachments

·
Ray Rowden
Joined
·
3,210 Posts
The geometry looks good - like a Y shaped natty sawed for a match stick match attachment.

I think that material setup is an innovation.

You are clearly doing your own thinking, bud!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top