Slingshots Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
OK, I'm guessing this type of fork has been done before....Maybe not? The fork is aluminum corner about 1" X 1", 1/8" in thickness, cut and shaped as you see - Handle is stabilized curly maple - I've marked where it could be made for tubes or flats or both - You can't them them but on the side of the fork I also put a mark for flat bands - I might even finish this one someday.....Maybe not!?!?
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top