Slingshots Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Hello everyone. This is my first Moorhammer build. It's kinda different, I was going to use Jorge Spraves design, but I decided something different. As you can see I laminated it 4x as here in Albuquerque NM I cannot find a 3/4 of an inch thick Birch plywood. I'm not sure if I should work on it some more or leave it as is. And I took the pictures of it right after I tested it out, works great and It's accurate!
 

Attachments

· Registered
Joined
·
22 Posts
Discussion Starter · #11 ·
That is well done. I suggest some finish, even rattle can, as raw BB grunges pretty fast.
or maybe use CA to seal first, then rattle can finish, like Minwax Poly ?
( the CA I think would really help hold the laminations together well at the edges )
@Kwionlgf
Can you please give me more information? This is my very first build so I don't know what to do next.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top