[Colorado CJ]

Hello everyone.

I decided to make another slingshot . This time, I tried to blend a few different designs together to make an OTT slingshot.

I am about to start milling out the aluminum center plate.

Might finish this tomorrow.

 

[Colorado CJ]

Well, I finished this one up today. After cutting the first core, I made a few changes. I adjusted the thumb area to make it larger and I also slightly raised the forks (4mm).

Today, I spent a good couple of hours shooting it at the shop. Fits my hand perfectly and was completely comfortable shooting the whole time. I am not sure which I'll like best in the long run, OTT or TTF, but I was pretty accurate with this one today. I'll probably end up making this same design in a TTF as it fits my hand a lot better than the R10 design I built last week.

Here it is!

_CFA0346-Edit-1 by Colo CJ, on Flickr

_CFA0352-Edit-2 by Colo CJ, on Flickr

_CFA0384-Edit-3 by Colo CJ, on Flickr

 

[Colorado CJ]

Thanks everyone!

I made another today without the aluminum core. I think I'm going to like this one even better. It is a little thinner and lighter, made from G10 sheet with 2mm CF sheet on the outside.

_CFA0405-1 by Colo CJ, on Flickr