Slingshots Forum banner
1 - 2 of 2 Posts

· Neophyte
Joined
·
2,312 Posts
Side question, is the frame covered in rubber tubing? If so any tips on getting it that far onto the frame and which type of tubing did you use? thanks for any info you can share :)
 
  • Like
Reactions: Bob E

· Neophyte
Joined
·
2,312 Posts
Side question, is the frame covered in rubber tubing? If so any tips on getting it that far onto the frame and which type of tubing did you use? thanks for any info you can share :)
Tubing has an ID of .187 and the frame is .250. The secret is coating the inside of the tube with dish soap and spreading it on the frame also.

Once about a half inch is slipped over the frame, grab that end with a dry towel and start working the tubing down the wire frame .... yes it is an ordeal for sure !

Don't remember the code# of the tubing, but I got it at Latex Tubing Supply Co.

wll

Sent from my SM-N975U using Tapatalk
Thanks! :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top