Slingshots Forum banner

Pfs tubes?

961 Views 9 Replies 6 Participants Last post by  vince4242
Anybody have any good suggestions for small but powerful tubes for shooting 3/8 steel?

All suggestions welcome

Thanks, Slingshot28
  • Like
Reactions: 3
1 - 10 of 10 Posts
I use single 2040s

Sent from my LE2117 using Tapatalk
  • Like
Reactions: 4
I am using 1745 + 2040 compound tubes. They work well.

Attachments

See less See more
  • Like
Reactions: 4
Are 1636 any good?
  • Like
Reactions: 2
I am using 1745 + 2040 compound tubes. They work well.
Hey that is neat, I would like to see how you set those up :)
  • Like
Reactions: 3
I am using 1745 + 2040 compound tubes. They work well.
Hey that is neat, I would like to see how you set those up :)
To insert one tube into another, use a round nose pliers or a circlip remover. Then, using two hemostatic clamps, I stretch it and tie it with an amber tape. I put a piece of tube on top of the winding for aesthetics. If it is not very clear, I will take a photo, but later.
  • Like
Reactions: 3
Are 1636 any good?
i use 1636 singles for 1/4 inch and 5/16s inch,double loops for 3/8sinch
  • Like
Reactions: 2
I am using 1745 + 2040 compound tubes. They work well.
Hey that is neat, I would like to see how you set those up :)
To insert one tube into another, use a round nose pliers or a circlip remover. Then, using two hemostatic clamps, I stretch it and tie it with an amber tape. I put a piece of tube on top of the winding for aesthetics. If it is not very clear, I will take a photo, but later.
Ahh I understand now, thank you for explaining that for me :)
  • Like
Reactions: 3
I do a loop 1632 tube set for my 8mm Steel. They are fast for target shooting and I believe 3/8" would also be fast enough for target shooting at a distance of 10 meters or less. Definitely not for hunting or longer than 10 meters in my opinion.

Cheers
  • Like
Reactions: 3
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top