Slingshots Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I am trying to switch things up since I am new and trying to find what I like to shoot and gives me the best combo of speed and accuracy. I currently shoot on single shot pre made 15mmx22mm .7mm thick bands for 3/8 steel. What would be a comparable setup with their .5mm latex? Is this a good thickness for 3/8 steel or should I continue with the .7mm latex. I have some bulk .7 and .5 I am going to cut but wondering if anyone uses .5 for 3/8 steel.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #4 ·
My draw currently is 29” don’t think I will be trying a longer draw anytime soon. I figure get a good setup and then when I get a lot better try some longer draws. I was getting some hand slap with the original simple shot setup, but seems as the bands wore in a little that went away.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top